<\/p>\n \n Functional block diagram of ADC<\/strong><\/p>\n \n The functionality of the A\/D module is controlled by three registers: ANSEL, ADCON0, and ADCON1.<\/p>\n The ANSEL register is used to configure the input mode of an I\/O pin to analog. Setting the appropriate ANSEL bit High will cause all digital reads on the pin to be read as 0, and allow analog function on the pin to operate correctly. The state of ANSEL bits has no effect on digital O\/P function. A pin with TRIS bit clear and ANSEL bit set will operate as digital O\/P but the input mode will be analog.<\/p>\n ANSEL register bits<\/strong><\/p>\n \n The ADCON0 register selects which analog input is to be measured. This is required, since there are several channels for\u00a0analog input but only one A\/D converter circuitry.\u00a0The channel select bits CHS0-CHS2 of ADCON0 register controls which analog channel is connected to the internal Sample and Hold circuit. For example, if you want to measure input analog voltage at AN2 (RA2) pin, you should set CHS1, and clear CHS0 and CHS2. The reference voltage used in the A\/D conversion process is software selectable to either Vdd or a voltage applied to the Vref pin (12). This is controlled by VCFG bit of ADCON0 register. If VCFG is set, the reference voltage for the A\/D conversion will be the voltage applied at the Vref pin. Bit 0 (ADON) of ADCON0 is the On\/Off switch for the A\/D converter. When it is set, the ADC is On, and the PIC microcontroller consumes extra current. GO\/DONE bit of ADCON0 is set to start an A\/D conversion cycle. It is automatically cleared by hardware when the conversion is done. This bit can, therefore, be tested to see if the A\/D conversion is completed or in progress.<\/p>\n ADCON0 register bits<\/strong><\/p>\n As mentioned earlier, the 10-bit digital output is held over two registers, ADRESH and ADRESL. You have a choice in how you want the 10-bit number stored into the two 8-bit registers. It can be right-justified by setting ADFM bit of ADCON0 so that bits 0:7 of the 10-bit result are held in ADRESL and bits 8:9 are stored in bits 0:1 of ADRESH. Similarly, clearing the ADFM bit shift the 10-bit output to the left. This is illustrated below.<\/p>\n Shifting the ADC result left or right with ADFM bit<\/strong><\/p>\n <\/a><\/p>\n The ADCON1 register also plays an important role in programming the A\/D module.\u00a0An ADC requires a clock source to operate. ADCS (A\/D conversion Clock Select) bits of ADCON1 register are the selection bits for the A\/D conversion clock. The conversion time per bit is defined as TAD<\/sub> in PIC documentation from Microchip.\u00a0The A\/D conversion cycle requires 11 TAD<\/sub>.\u00a0For correct conversion, the A\/D conversion clock\u00a0(1\/TAD<\/sub>) must be selected to ensure a minimum TAD<\/sub> of\u00a01.6 ?s. In PIC16F688, there are\u00a0seven possible clock options for A\/D conversion that are software selected, as shown below.<\/p>\n Software selectable clock sources for A\/D conversion<\/strong><\/p>\n \n![\"\"](\"http:\/\/embedded-lab.com\/blog\/wp-content\/uploads\/2010\/10\/PIC16F688.png\" "\\"PIC16F688\\"")
<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n