Product Review | Embedded Lab

Category Archives: Product Review

MikroElektronika’s “Ready for PIC” board talks to “Processing”

Posted on September 17, 2011 by R-B 3 comments

“Ready for PIC“ is one of MikroElektronika‘s compact prototyping boards for 28 and 40 pin PIC microcontrollers. The board comes with PIC16F887 microcontroller which is preprogrammed with an UART bootloader firmware and thus eliminates the need of an external programmer. The on-board USB-UART module allows the serial data transfer between the PIC and a PC using an USB cable. It has also got a reasonable size prototyping area to add more functionalities to the board as required. These features make this board an ideal candidate for doing embedded projects that require PC interfacing. This article first reviews the basic features

Amicus18: Arduino-style platform for PIC fans

Posted on September 4, 2011 by R-B 7 comments

Arduino needs no introduction; it is an easy-to-use yet powerful open source embedded system development platform that has gained huge amount of popularity in past few years, specially among hobbyists. The standard hardware consists of an 8-bit Atmel AVR processor with on-board headers providing access to its I/O pins. The processor is pre-programmed with a serial bootloader that simplifies the uploading of user programs to the on-chip flash memory without the need of any external programmer. Because of its low cost, user-friendly software development environment (open-source C/C++ like programming platform), rich set of libraries, and tons of resources available online,

UNI-DS6 development board for experimenting with dsPIC30F6014A

Posted on July 1, 2011 by R-B 2 comments

UNI-DS6 is an universal development board from mikroElektronika for experimenting with a wide range of microcontrollers including PIC, AVR, dsPIC, ARM, and 8051. I am going to use this board to educate myself about Microchip’s dsPIC Digital Signal Controllers (DSCs). The dsPIC DSCs are 16-bit high performance microcontrollers and more powerful than regular PIC devices. They are special because they combine the best features of microcontrollers with the computational capabilities of a Digital Signal Processor (DSP), and they are capable of doing complex mathematical operations involving Fourier transforms. I am going to describe briefly about the features of UNI-DS6 board

Getting started with PIC18F Microcontrollers

Posted on April 6, 2011 by R-B 14 comments

After writing quite a bit of experimental tutorials on PIC16F series of microcontrollers, I thought of moving forward to the enhanced-range family of PIC microcontrollers, the PIC18F, which was introduced by Microchip in late 90s. Although PIC16F series are excellent general purpose microcontrollers, certain limitations have emerged, such as, they have limited program and data memory, their stack size is small, and all the interrupt sources have to share a single interrupt vector. Their limited instruction set also doesn’t provide direct support for more advanced peripherals interfaces like USB and CAN. The basis of the PIC18F Series is to address

Choosing a PIC Programmer

Posted on November 5, 2010 by R-B 25 comments

If you are a beginner in the world of PIC microcontrollers then you will probably have this question in your mind: Which programmer should I buy? This is an obvious question because there are tons of PIC programmers available from various vendors and if you search on the various online technical discussion forums for their reviews, everybody has his own opinion. This will confuse you more, and you will be ended up with nothing. I would suggest, just buy one that you can afford and that fulfills your need. Having said that, I won’t recommend to buy one that requires