TrH Meter: A DIY indoor thermometer plus hygrometer with adaptive brightness control implemented to 7-segment LED displays

Posted on by 11 comments

This project is about building a microcontroller-based digital room thermometer plus hygrometer that displays temperature and relative humidity on 4 large (1 inch) seven segment LED displays which adjust their brightness level according to the surrounding illumination. It consists of a closed loop system that continuously assesses ambient light condition using an inexpensive light-dependent resistor (LDR) and uses that information to adjust the brightness of the display. An inexpensive DHT11 sensor is used to measure temperature and relative humidity. The microcontroller used in this project is PIC16F688, and it runs at 4 MHz clock generated from its internal source. A

Read more

More PIC16F628A/PIC16F84A/PIC16F88/PIC16F1847 breakout board kits are available on Tindie

Posted on by Leave a comment

The 18-pin PIC16F series microcontrollers are still very popular among hobbyists and beginners because of their compact size, low cost, and simplicity. The PIC16F1847 is the latest release in this series and is equipped with lot more peripherals and enhanced features than its predecessors. This breakout board provides all the basic elements that are required to get you going with your next project using PIC16F1847 or its predecessors, including PIC16F628A, PIC16F88, PIC16F84A, and PIC16F1827. More details of this board are found here: http://embedded-lab.com/blog/?p=5625 You can buy the breakout board kit with one PIC16F1847 microcontroller included for $13.00. Here’s the buying

Read more

More SPI 4-digit seven segment LED displays are available

Posted on by Leave a comment

Four digit SPI 7-segment LED displays are back in stock now on Tindie. The board has been revised from its earlier version and now contains an additional header connector to cascade multiple displays. The new header provides access to DOUT pin of MAX7219 driver IC. If you want to add a seven segment LED display to your project without giving up too many I/O resources, this board allows you to do that using only 3 I/O pins and it costs only $10. Tindie buying link for SPI 4-digit seven segment LED display  

Read more

USB keyboard turns into an AVR programmer

Posted on by Leave a comment

If you have an old USB keyboard that is just laying around and not usable anymore, you might consider converting it into an AVR programmer. This project from Steve is about constructing an AVR programmer using an USB keyboard controller board and an optocoupler. Steve writes, “Most keyboards have at least three indicator LEDs (Num-, Caps- and Scroll-Lock), which can be controlled from the host using a HID Set_Report request, and thus can be used as general purpose outputs. The inputs are a bit more tricky, since the keyboard uses a scan matrix divided in rows and columns. Most keyboards

Read more

New Easy Pulse boards with red solder mask

Posted on by 3 comments

New Easy Pulse PCB boards are now available with red solder mask. You can buy PCB only for $5.00, PCB+TCRT1000 sensor for $7.00, or complete Easy Pulse kit for ($15.50), and are available on Tindie. Tindie link: Buy PCB only Tindie link: Buy PCB+TCRT1000 If you buy a full kit you will receive all the parts to assemble the board, which will look like as shown below. Tindie link: Buy complete kit Easy Pulse board provides a reflective IR sensor with necessary instrumentation circuit to illustrate the principle of photoplethysmography as a noninvasive technique for measuring heart rate. It uses the TCRT1000

Read more
« Older Entries Recent Entries »