Category Archives: Featured


Wifi enabled 8×64 pixel LED matrix display

Posted on by 26 comments

This project is a modification of my previous Bluetooth-enabled LED matrix display project, which used 8×64 monochromatic LED matrix (total 512 LEDs) for displaying scrolling text message. The original project used Bluetooth for display data transfer from a smartphone, but this one now uses Wifi. The display message is sent through web browser to a ESP8266 module that is configured as a web-server. No Arduino or any other microcontroller is used. ESP8266 alone works as a WiFi server and drives the MAX7219-based LED matrices.

Read more

A very simple DIY solar-powered USB charger

Posted on by 4 comments

Yesterday, I built a very simple DIY solar-powered USB charger for my TP-link 10400mAh USB Power Bank. All I needed was a 6V/3.5W solar panel and the TD1410-based 5V buck converter module. I bought both of them on Aliexpress for less than $8. It was one of the easiest projects I built. All I needed to do was to connect the input of the 5V step-down buck converter to the output of the solar panel using two wires. From TD1410 datasheet, The TD1410 is a 380 KHz fixed frequency monolithic step down switch mode regulator with a built in internal Power MOSFET. It achieves 2A continuous output current

Read more

Using Easy Pulse mikro with MPLAB Xpress board

Posted on by 2 comments

Easy Pulse mikro is our new educational pulse sensor in a mikroBus form factor. Like our previous Easy Pulse sensors (Easy Pulse and Easy Pulse Plugin), it is also based on the principle of transmittance photoplethysmography (PPG) applied to a fingertip. The sensor consists of a pair of IR LED and photodiode to detect the cardiovascular pulse signal from the fingertip. The output of the sensor is passed through a necessary instrumentation amplifier to derive a nice and clean analog PPG waveform. The analog output is routed to the AN pin of the mikroBus connector. In this article, I will describe how

Read more

Development board for PIC16F1938

Posted on by One comment

The PIC16F1938 is a versatile 28-pin MCU belonging to Microchip’s extreme low power microcontroller family featuring nanoWatt XLP technology, 28KB of programming memory, 1KB of RAM, 11 ADC channels, and tons of other peripherals. A while ago, I designed a development board for this MCU and I thought it would be worth sharing this design here. The development board features an onboard USB-UART bridge to support the ds30 Loader for easy programming of the PIC MCU. All I/O pins are accessible through 2×5 headers. Summary of Features: On-board 5V and 3.3V regulators Support both 5V and 3.3V MCUs. The power

Read more
Recent Entries »