A DIY I/O board for experimenters

I remember when I first stepped into the world of embedded electronics, I started with doing some basic microcontroller circuits on a breadboard. Breadboard is a wonderful tool for prototyping and testing circuits. When the test of a circuit is successful, you can dissemble it and the board is ready for a new circuit. While working on breadboard was a great learning experience, it was little bit frustrating sometimes when you realized after dissembling a circuit that you have to put it together again or just a part of it for your new project. It happens very often because most embedded projects require some common stuff, basically I/O devices such as switches, LEDs, LCD display, buzzer, etc. Connecting these things on the breadboard for every new project is time consuming and boring. If you are a newbie and having the similar experience, here I suggest a general purpose I/O board that will not only reduce your prototyping time but also free up plenty of space on the breadboard for your project.

DIY I/O board for experimenters

The construction of this board is very simple. You can solder basic I/O devices of your choice (that you use more frequently) on a general purpose perforated board and provide access to them through headers. The board that I constructed is shown below. It has got an LM7805 IC that provides a regulated +5 V power supply to rest of the devices on the board. A 16-pin female header is a plug-in for an HD44780-based alphanumeric LCD. The four data pins (D4-D7) and two control pins (Register Select, RS, and Enable, E) of the LCD are accessible through female headers, as shown on the bottom left part of the board. A potentiometer is also available on the board to adjust contrast of the display.

Construction of a general purpose I/O board

Four tact switches, four LEDs, and one coil buzzer serve as basic input and output devices. In this particular version, I have also added a LM34DZ temperature sensor device along with an I2C compatible serial EEPROM (24LC512). There’s plenty of prototyping space available for extending the functionality of the board in future.

I/O board with LCD plugged-in

The circuit diagram of this project is very simple. There is nothing special as each component is independent and is not connected to any other component. The only common thing in them is all of them share the same Vcc and Gnd terminals. I have provided the following schematics for reference purpose.

Circuit diagram of the I/O board

I2C device and buzzer connections

Complete circuit on a perforated circuit board

Bottom view of the I/O board

Testing the board

PIC16F1827 on breadboard reads LM34 output and displays temperature

Testing the I/O board with Amicus18

I tested the LCD with Amicus18 board, and the 3.3 V logic output of the Amicus18 processor successfully drove the LCD data and control pins (although the LCD is powered by +5 V supply).

Summary

We discussed about a general purpose I/O board that is easy to construct and is very useful for rapid prototyping of microcontroller-based projects. The board can be made more versatile by adding further devices like RTC, seven segment LED display, digital potentiometer, etc. All the necessary pins of the devices on the board are accessible through female headers that allows easy connection of the board to a breadboard circuit or other development boards (Arduino and Amicus18, etc) using male jumper wires.

Related Posts

14 comments

Leave a Reply

Your email address will not be published. Required fields are marked *